Demounting and replacement | Valve amplifier VT-MSPA2-2X
11 Demounting and
replacement
11.1
REQUIRED TOOLS
For replacement, a screwdriver is necessary.
11.2
PREPARING DEMOUNTING
Risk of injury by demounting parts under pressure and electric voltage!
If you do not de-pressurize and de-energize the system before starting
demounting, you may get injured and the product or system parts may be
damaged!
▶ Decommission the entire system as described in the general instructions for
the system.
▶ The system and all connected components must be brought to a safe state. In
addition, the components must be switched off, de-pressurized, de-energized
and secured against restarting.
Decommission the entire system as described in the general instructions for the
system. In any case, bring the system to a safe state, shut it down, depressurize
and disconnect it from the power supply and secure it against being switched on
again.
11.3
DEMOUNTING THE VALVE AMPLIFIER
Electric arc and short-circuit!
Risk of destruction of system components.
▶ Put plug-in connectors down in a way that no short-circuit fault can occur.
WARNING
NOTICE
RE 30232-02-B, Edition 02.2021, Bosch Rexroth AG
29/36