Table of Contents
Advertisement
ACXF55-2248̲OL.ai 11 1/27/2020 7:13:15 PM
ACXF55-2248̲OL.ai 11 1/27/2020 7:13:15 PM
nanoe-G
nanoe-G
PURIFIER
• nanoe-G starts automatically when the unit is
turned on with
• Can be activated even when the unit is turned
off. In this condition, the unit will operate as a fan
with AUTO fan speed and louver swing.
To select fan speed
(Remote control display)
AUTO
FAN
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
C
To adjust airflow direction
M
Y
(Remote control display)
CM
(Vertical)
MY
CY
(Horizontal)
• Keeps the room ventilated.
CMY
• If AUTO air swing is set, the flaps swings
left/right and up/down automatically.
K
• The horizontal and vertical flap are fixed at the
predetermined position.
• Do not adjust the flap by hand.
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a period
of time with previous operation mode and airflow
direction.
• This control is not applicable when TIMER is set.
.
(Low)
(Medium)
(High)
To set the timer
To turn ON and OFF the unit at a preset times.
1
2
3
1 Select ON or OFF
Example:
timer
OFF at 22:00
• Each time pressed:
Cancel
2 Set the time
3 Confirm
• To cancel ON or OFF timer, press
then press
.
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
pressing
or
then press
• The nearest timer setting will be displayed and
will activate in sequence.
• When ON Timer is set, the unit may start
earlier (up to 15 minutes) before the actual
set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in
the remote control and repeats daily once set.
For clock setting, please refer to Quick guide.
Operation conditions
Use this air conditioner under the following
temperature range.
DBT : Dry bulb temperature
WBT : Wet bulb temperature
TIMER
or
.
50
30
11
Advertisement
Table of Contents
