Connecting Via Wps - Miele DA 4248V D Operating And Installation Instructions

Connecting via WPS

Your WiFi router must support WPS
(WiFi Protected Setup).
 Switch the ventilation hood off.
 Press and hold the  control.
 Press the lighting control  at the
same time.
2 will light up constantly, 3 will flash on
and off.
The WiFi connection must be started on
the ventilation hood at the same time as
on the WiFi router.
 Press the  control on the ventilation
hood after a few seconds.
After a short while, 2 will light up
constantly, and 3 and B will flash on
and off.
The ventilation hood is ready for
connection in the next two minutes.
Before using for the first time
 Start the WiFi connection on your
router.
When successfully connected, 2 and 3
will light up constantly.
 Quit connection mode on the
ventilation hood by pressing the
delayed shutdown control .
The ventilation hood can now be
operated via the app.
If the connection fails, you have
probably not connected WPS to your
router quickly enough. Repeat the steps
above.
Tip: If your WiFi router does not support
WPS, please connect via the Miele app.
19