Wickes 223734 Manual page 10

Fig. A3
1
Fig. A5
2. MOUNTING THE SANDING PAPER (SEE FIG. B1,
B2)
1) Mount the sanding pad following the steps of
mounting the end cut blade.
2) Align the sanding paper and press it onto the
sanding pad by hand.
3) Firmly press the power tool with the sanding paper
against a flat surface and briefly switch the power
tool on. This provides for good adhesion and
prevents premature wear.
4) If one point has become worn, pull off the sanding
paper, turn it 120° and place it on again.
b
2
c
Fig. A4
Fig. A6
Fig. B1
Fig. B2
10