Dell PowerVault 530F Software Update page 10

To restore the configuration files from the backup diskette, perform the following
8
steps:
a
b
c
d
Repeat steps 5 through 8 to restore the configuration information for any additional
9
PowerVault 530F systems.
See "Verifying the System Operation" to confirm that the restored configuration
10
settings are correct.
Verifying the System Operation
After upgrading the PowerVault 530F software and restoring the configuration information,
perform the following steps.
NOTICE: If any of the following steps do not yield expected results, troubleshoot each
problem individually. For troubleshooting information, see your system's User's Guide ,
Service Manual , and System Administrator's Guide for more information.
From the system used to manage the PowerVault 530F, launch the Web browser and
1
log into the PowerVault 530F.
Click the Node Conf tab and verify that the system properly restored the original
2
configuration information.
Click the LUN Map tab and verify that the LUN-to-host mapping was restored.
3
Turn on all attached servers.
4
If your servers are MSCS nodes, enable the Cluster Disk Resource in Device Manager
5
and set the Cluster Service option to Automatic in the Services applet, and then
reboot the MSCS nodes.
Check all servers for proper access to previously mapped LUNs.
6
Verify that all Fibre Channel Protocol (FCP) and IP mirrors are synchronized.
7
1-8
Up g r a d i n g Yo u r S y s te m S o f t war e
Access the SAN Appliance Menu from an attached keyboard/video/mouse.
From the SAN Appliance Menu, select Tools, and then click Restore
Configuration.
Follow the prompts on the screen to restore the configuration backup.
When the restore has completed, remove the backup diskette and reboot the
PowerVault 530F.