Haier HW100-B14636N User Manual page 20

8-Care and cleaning
8-6
Note: Hygiene
After long periods of disuse we recommended to run programme HYGIENE with no
load and small amount of detergent in washing agent compartment (2) or special ma-
chine cleaner to remove possibly corruptive residues.
8-8
8-10
8-12
20
8.5 Long periods of disuse
8-7
If the appliance is left idle for a longer period:
1. Pull out the electrical plug (Fig. 8-6).
2.
3. Open the door to prevent formation of moisture
Before next usage check carefully power cord, water
inlet and drain hose. Make sure everything is properly
installed and without leakage.
8-9
for instanvce if the appliance:
8-11 hot! Before any action please ensure water has
cooled down.
1.
2. Open service flap. You can either use a coin or a
3. Provide a flat container to catch leach water
4. Pull the drainhose out and hold its end above the
8-13
5. Take the sealing plug out of the drainhose (Fig.
6. After complete drainage close drainhose and
7. Unscrew and remove counter clockwise the pump
8. Remove contaminants and dirt (Fig. 8-13).
and odours. Let door open while not used.
Doesn´t drain the water.
Doesn´t spin.
Cause unusual noise while running.
WARNING!
screwdriver (Fig. 8-9).
(Fig. 8-10). There could be bigger amounts!
container (Fig. 8-10).
8-10).
push it back into the machine (Fig. 8-11).
GB