Download Print this page

Dell 6350 Rack Installation page 25

Dell poweredge 6350 servers: installation guide
Hide thumbs Also See for 6350:

Advertisement

support.dell.com
7 .
At the back of the cabinet, pull back on the mounting-bracket flange until the
mounting hooks are located in their respective square holes, and then push down
on the mounting-bracket flange until the mounting hooks engage the square
holes on the back vertical rail, allowing the push button to pop out and click.
8.
Repeat steps 3 through 7 for the remaining slide assembly on the other side of
the rack.
'       

1.
Pull the two interior slide assemblies out of the rack until they lock in the
extended position.
2.
Lift the computer into position.
3.
Tilt the front of the computer upward while aligning the back shoulder screws on
the sides of the computer with the back slots on the slide assemblies (see
Figure 1-9).
4.
Engage the back shoulder screws in the slot just behind the back (green) latch
first, followed by the middle shoulder screw in the slot near the middle (yellow)
latch. Finally, engage the front shoulder screw in the front slot.
5.
Push the computer inward on the slide assemblies until the middle (yellow) latch
clicks into place, locking the slide to the middle shoulder screw (see Figure 1-9).
Rack Installation Guide
1-11

Advertisement

loading

This manual is also suitable for:

Powervault 530fPoweredge 6x50