Dell 6350 Rack Installation page 23

support.dell.com
To determine where to install the slide assemblies in the rack, perform the following
steps:
1. Place the front of the template on the vertical rails at the front of the rack where
you want to install the computer.
The printing on the template identifies the side facing outwards as the template
front.
2. Position the bottom of the template where the computer's lower edge will be
located.
3. Mark the rack's front vertical rails with a felt-tip marker or place masking tape
where the system's upper and lower edges will be located (see Figure 1-7). Make
a mark or place tape on the vertical rails next to the template's V-shaped notches.
4 U (7 inches) between
slide assemblies
(drawing is not to scale)
rack template

 " #  $ %   
4. At the front of the rack cabinet, position one of the slide assemblies so that its
mounting-bracket flange fits between the marks or tape you placed on the rack
(see Figure 1-8). The hooks on the mounting-bracket flange should align with the
marks you made from the V-shaped notches in the template.
Rack Installation Guide 1-9