System Error Messages; Table 3-2. System Messages - Dell 6100 Service Manual

3-2 Dell PowerEdge 6100/200 System Service Manual
Table 3-1. Beep Codes (continued)
Beep Code Error
10 Shutdown reg. read/write error
11 I2C error
S
ystem Error Messages
Table 3-2 lists system error messages that can appear on the monitor screen.
These messages can help you find the source of a problem. Some of these error
messages indicate fatal errors. When a fatal error occurs, the system cannot usu-
ally be rebooted until an appropriate hardware change has been made.
Code Message
Primary Boot Device Not Found
0002
Cache Memory Failure, Do Not Enable Cache
0010
Primary Output Device Not Found
0015
Primary Input Device Not Found
0016
EISA ID Mismatch for Slot
0041
EISA Invalid Configuration for Slot
0043
EISA config NOT ASSURED!
0044
EISA Expansion Board Not Ready in Slot
0045
EISA CMOS Configuration Not Set
0047
EISA CMOS Checksum Failure
0048
EISA NVRAM Invalid
0049
Keyboard Is Locked ... Please Unlock It
0060
CMOS Time & Date Not Set
0070
Option ROM has bad checksum
0080
Shadow of PCI ROM Failed
0083
Shadow of EISA ROM Failed
0084

Table 3-2. System Messages