Operation; Maintenance - Profile 545142002 Manual

Table Fan
545142002/545142003/545142007
WARNINGS
•
Never place the fan near flammable liquids and units operating on gas.
•
Make sure that the fan cannot come into contact with water or other liquids, this can lead to the
risk of electric shock.
•
Do not insert objects or fingers in the rotating fins of the unit. Protect your children from this
danger.
•
Never try to repair the unit yourself. All interventions that are performed by an unauthorised
person could be dangerous; the warranty will be void in this case. Also the replacement of the
power cord needs to be performed by a qualified electrician
•
Use this unit only inside and operate it according to these instructions. Do not use the unit for
other purposes.
•
Do not use the unit outside and always place it in a dry environment.
•
Check the power cord from time to time. Never use the power cord, plug or appliance when they
are damaged.
•
Unplug the fan from the outlet before moving the fan.
•
Unplug the fan before cleaning the fan.
•
Make sure the fan is on a flat and stable surface during operation so that it cannot fall over.
•
Never use an extension cord.
•
Do not use chemical products to clean the fan.
•
Make sure that children are supervised by an adult when they are near a working fan.
ASSEMBLY
•
Click the fan on the base (foot) (1)
•
Remove the nut and rotating part of the motor coil
•
Place the grill in front of the backside. Make sure that it fits perfectly on the brackets as shown
and fasten the grill by firmly tightening the nut (A). (2)
•
Place the ventilator blade. Make sure that the pin on the motor coil fits in the fan blade recesses.
Fasten the fan blade by tightening the rotating part (B) (turn anticlockwise). (3)
•
Place the white decorative plate on the front of the grill (front) and fasten it with the white plug (4)
•
Click the mounting brackets on the grill from the front towards the outside. Then place the grill
(front) and attach it by clicking the brackets back down. Insert the fixing screw (5)

OPERATION

•
To make the fan head swivel or put it in a fixed position use the swivel button, it is operated by
pulling it out or pushing it in.
•
You can set the speed of the fan on the front of the unit with 4 (545142002 & 545142003) or 3
(545142007) push-buttons:
0 = off / 1 = low / 2 = medium / 3 = high (only 545142002 & 545142003)

MAINTENANCE

Warning:
To prevent an electrical shock you should turn the unit off and unplug it from the wall outlet before you
start any maintenance or repairs.
EN - 3