Table of Contents
Advertisement
Adjusting the salt consumption
The salt consumption can be adjusted according to
your water hardness and therefore optimally regulat-
ed.
Turn on the appliance.
Press the Program button for more than
5 seconds, the setting mode is now activated for
approx. 60 seconds.
By repeatedly pressing the Program button the
water hardness can be selected: H1->H2->H3
->H4->H5->H6. The display indicates the selec-
tion (see below table).
The setting is automatically saved after a few
seconds; alternatively end the setup with the
Power button.
Water hardness
Setting /
Display indicator
°dH
Mmol/l
0-5
0-0.94
H1
6-11
1.0-2.0
H2
12-17
2.1-3.0
H3 (factory setting)
18-22
3.1-4.0
H4
23-34
4.1-6.0
H5
35-55
6.1-9.8
H6
NOTE:
°dH: German degree of hardness
Fill in the salt
CAUTION:
Only refill the salt container when the salt warning
lamp is lighting.
During filling the salt container, salt and water can
escape. Start a program immediately after you
have filled the container to prevent corrosion.
Remove the lower basket and unscrew the lid of
the salt container.
Add about 1.5 kg of salt by using the supplied
funnel tube.
Full fill the salt container with water (just before
the first use).
Screw the lid firmly on again after filling the con-
tainer.
Depending on salt resolution, the warning lamp
usually disappears immediately after filling.
Fill the rinse aid dispenser
B.
Function of rinse aid
The rinse aid is automatically added during the final
rinse, ensuring thorough rinsing and a spot and
streak free drying.
When to refill the rinse aid dispenser
Salt cons. /
cycle
0 g
9 g
12 g
optical level indicator (D) next to the dispenser.
20 g
When the rinse aid dispenser is full, the indicator is
30 g
completely dark. If the rinse aid diminishes, the size
60 g
of the black dot changes as shown below. In order to
avoid spotting, the rinse aid level must not drop be-
low ¼.
full
Fill in the rinse aid
To open the dispenser, screw the lid counter-
clockwise to the open position and remove the lid.
Add the rinse aid into the dispenser, being careful
not to overfill. The dispenser contains approx.
110 ml.
Before closing the appliance door, put on the lid in
the open position back and turn it clockwise to the
closed position.
8
If the corresponding message
does not light up in the display,
you can estimate the amount
of remaining rinse aid to the
¾ full
½ full
¼ full
empty
Advertisement
Table of Contents
