BOMANN GSP 7411 IX Instruction Manual page 6

 Place the appliance so that all controls are easily
to reach, and the appliance door can open without
being impeded.
 Take care of a solid and horizontal position of the
appliance. If the appliance is not horizontally lev-
eled, adjust the feet accordingly (see "Adjust the
feet").
 Power cord and water hoses may not kinked or
squashed.
 Avoid the installation:
near heaters, next to a stove, direct sunlight
-
or any other heat sources;
at locations with high humidity (e.g. out-
-
doors), as metal parts would be susceptible
to corrosion under such circumstances;
in rooms where the temperature could drop
-
below freezing. Do not expose the appliance
any weather.
near volatile or flammable materials (e.g.
-
gas, fuel, alcohol, paint, etc.).
Removing the appliance cover
The appliance cover can be removed and thus re-
ducing the device height to 81.5 cm; to place the
dishwasher under a suitable kitchen worktop.
a) Loosen the screws on the unit
b) After removing the cover, re-
Adjusting the feet
Check with a spirit level whether
the appliance is leveled horizon-
tally. If the unit is not in balance,
the feet must be adjusted.
back and remove the cover.
tighten the screws.
Water connection
CAUTION:
 The Installation of the water supply must conform
to the local laws and regulations.
 The appliance is not suitable for hot water supply.
 Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
 If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.
Notes on inlet hose safety system
(delivery scope depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop, www.bomann-germarny.de. To order, use the
reference number found under "Technical Data".
Connect the water inlet hose (cold water connection)
NOTE:
The water pressure must be between 0.04-1.0 MPa.
With higher pressure: use a pressure regulator.
 Connect the water inlet hose to a
water thread with ¾". Screw the
hose firmly in the direction of the
screw thread; pay attention for a
tight fit.
 Connect the other end of the inlet
hose to the inlet valve on the ap-
pliance back; pay attention for a
tight fit too.
6