BOMANN GSP 7411 IX Instruction Manual page 16

Changing the program
CAUTION:
A program change should be done only a short time
after starting the program. Otherwise, maybe deter-
gent has been released and already drained rinse
water.
 First press the Start/Pause button to stop the
current rinse program.
 Press the Program selection button for about
3 seconds.
 Select a new program and start the new opera-
tion.
Forgot to add a dish?
WARNING:
Open the door very carefully during operation, there
is a risk of water squirting out.
Dishware can be added any time before the deter-
gent dispenser opens.
 Press the Start/Pause button to stop the opera-
tion. Once the spray arms have stopped, you can
fully open the appliance door.
 Add forgotten dishware.
 Press the Start/Pause button, the operation will
continue after approx. 10 seconds.
At the end of program
CAUTION:
Allow the appliance to cool down a bit after the pro-
gram has ended, before you open it. This avoids that
steam escapes that causing long-term damages to
your furniture.
At the end of the rinse cycle will sound a series of
signals; then the unit goes into standby mode.
If no operation takes place within 15 minutes, the
device switches off automatically - energy-saving!
Turn off
 Turn off the appliance.
 Close the water supply, if necessary!
 Remove the dishes after cooling (see "Unloading
the dishwasher").
 Leave the appliance door slightly open until the
next rinse cycle to avoid odors.
 If the appliance is not in use for an extended peri-
od, disconnect it from the power supply!
Unloading the dishwasher
CAUTION:
Let the dishware cool down for about 15 minutes
before unloading. Hot dishes are sensitive to knocks.
NOTE:
At the end of program there could be still water drops
inside the appliance.
 Open the appliance door and pull out the basket.
 To avoid water dripping from the upper basket
onto the dishes in the lower basket, it is advisable
to unload the appliance from the bottom up.
Energy saving tips
 Always try to operate the dishwasher when it is
fully loaded.
 Do not rinse the dishes in advance under running
water.
 Use for each type of load the most appropriate
rinse program.
 Do not perform a pre-rinse (depending on model),
if not necessary.
16