General Overview - Husqvarna QTB380W User Manual

It must be possible to
disconnect the appliance
from the mains power
supply. The plug must
therefore be easily
accessible after installation.
3.3 Positioning
This appliance is not intended to be
used as a built-in appliance.
This appliance should be installed in a
dry, well ventilated indoor position.
This appliance is intended to be used at
ambient temperature ranging from 10°C
to 43°C. The correct operation of the
appliance can only be guaranteed within
the specified temperature range.
If you have any doubts
regarding where to install
the appliance, please turn to
the vendor, to our customer
service or to the nearest
Authorised Service Centre.
3.4 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
3.5 Handle installation guide
1. Take out the handle base and 4
screws from the plastic bag.

4. GENERAL OVERVIEW

2. Place the handle in position
according to the picture. Use Phillips
screwdriver to fix the handle base to
the lid.
3. Take out the handle cover from the
plastic bag. Press it to the front side
of the handle base. Make sure that
the fasteners of the handle cover are
aligned with the assembly holes of
the handle base.
Open and close the lid several times to
make sure the handle is properly
fastened.
ENGLISH 25