9. TECHNICAL DATA ............20 DEAR CUSTOMER Thank you for choosing this Husqvarna-Electrolux product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...
ENGLISH SAFETY INSTRUCTIONS In the interest of your safety and to en- 1.2 General safety sure the correct use, before installing WARNING! and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mis- Keep ventilation openings, in the appli- takes and accidents, it is important to ance enclosure or in the built-in struc-...
WARNING! • Appliance's manufacturers storage Any electrical component (power recommendations should be strictly cord, plug, compressor) must be adhered to. Refer to relevant instruc- replaced by a certified service tions. agent or qualified service per- • Do not place carbonated or fizzy sonnel to avoid hazard.
ENGLISH • The appliance must not be located ozone layer, in either its refriger- close to radiators or cookers. ant circuit or insulation materials. The appliance shall not be dis- • Make sure that the mains plug is ac- carded together with the urban cessible after the installation of the ap- refuse and rubbish.
2.1 Display Timer To disconnect the appliance from the power disconnect the mains Frostmatic mode plug from the power socket. Minute minder mode Temperature indicator 2.4 Temperature regulation Night mode The set temperature of the freezer may Alarm indicator be adjusted by pressing the temperature Ice maker function button.
ENGLISH Press the ChildLock button for 3 sec- The Minute Minder indicator goes onds. off. It is possible to change the time during The ChildLock mode indicator goes the countdown and at the end by press- off. ing the Temperature button. 2.7 FROSTMATIC mode 2.9 High temperature alarm To switch on the function:...
2.13 Switch off the lighting 2.15 Dispensing of ice Make sure that the ice dispenser is The dispensing of ice start when the unlocked. paddle is fully depressed and continues until the paddle is released. Press the Light button and the light- Stop delivery by removing the container ing goes out.
ENGLISH 3.4 Removing the ice container The ice container can be removed. Tilt up and pull the ice container outwards to removal. When the ice container is pulled out, this stops all the functions of the ice machine. When refitting (if necessary) the ice container feed screw should be posi- tioned against the rear flange.
Page 10
3.6 Removal of freezing baskets and glass shelves from the freezer Some of the freezing baskets have a limit stop to prevent their accidental removal or falling out. At the time of its removal from the freezer, pull the basket towards yourself and, upon reaching the end point, remove the basket by tilting its front upwards...
ENGLISH 3.7 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abra- sive powders, as these will dam- age the finish.
5. CARE AND CLEANING CAUTION! Do not use detergents or abra- Unplug the appliance before car- sive paste as these will damage rying out any maintenance oper- the paint, or stainless steel anti ation. finger print coating. This appliance contains hydrocar- After cleaning, reconnect the equipment bons in its cooling unit;...
ENGLISH If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. 5.5 Cleaning the ventilation grille The ventilation grille can be removed for washing.
Page 14
Problem Possible cause Solution Upper or lower An error has occurred in Call your service represen- square is shown in measuring the tempera- tative (the cooling system the temperature dis- ture. will continue to keep food play. products cold, but temper- ature adjustment will not be possible).
Page 15
ENGLISH Problem Possible cause Solution The appliance has no Connect another electrical power. There is no volt- appliance to the mains age in the mains socket. socket. Check fuse. Con- tact a qualified electrician. No ice. The ice maker is not Refer to "Ice maker func- switched on.
7. INSTALLATION WARNING! Cli- Ambient temperature Read the "Safety Information" mate carefully for your safety and cor- class rect operation of the appliance before installing the appliance. +10°C to + 32°C +16°C to + 32°C 7.1 Positioning +16°C to + 38°C Install this appliance at a location where +16°C to + 43°C the ambient temperature corresponds to...
ENGLISH 7.4 Removing the transport support Your appliance is equipped with trans- port support to secure the door during transportation. To remove them do these steps: • Open the door. • Remove the transport support from the door sides. • Remove the transport support from the lower hinge (some models).
Make sure that the gasket is properly refrigerators and freezers, which makes it positioned in the connector. easier to detect possible leakage. We recommend that the appliance is placed on a "run-off" mat intended for 7.7 Levelling When placing the appliance ensure that it stands level.
9. TECHNICAL DATA Dimension Height 1800 mm Width 595 mm Depth 650 mm Rising Time 10 h Voltage 230 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Water pressure range The water pressure must be at least 1 bar Consult your installer if water...