Dell PowerVault 120T User Manual page 2

  

  
 
10. Go to the temporary directory where files were unzipped and run the setup
program.
11. Run ARCserve Device Configuration to configure the Autoloader.

   
To make your PowerVault 120T DDS4 compatible with ARCserveIT 6.6 for NetWare,
perform the following steps:
1. Register devices with more than one logical unit number (LUN) by adding the
driver switch   to the driver command line along with a Novell
command
   in the startup.ncf file.
a. Open the startup.ncf file in c:\nwserver directory.
b. Go to the driver line that corresponds to the SCSI controller the Autoloader is
connected to.
For example, if the Autoloader is connected to the Adaptec 2940, it should
look similar to the following driver line:
  !  !"#$%&"'  (&  
At the end of the file, type
   .
c.
d. Save the startup.ncf file.
e. Restart the Netware server.
2. Go to http://support.cai.com.
3. In the Support by Product drop-down menu, select ARCserve/ARCserveIT .
4. Click ARCserveIT 6.6 for NetWare under Technical Information by Product.
5. Click Latest Patches for ARCserveIT 6.6 for NetWare under Solutions &
Patches.
6. Click LO70914.ZIP in the Base Product Enterprise Edition — ARCserveIT 6.6
for NetWare table.
7 . Scroll to the end of the page.
8. Click LO70914 to download.