Champion Power Equipment 100536 Operator's Manual
  1. Manuals
  2. Brands
  3. Champion Power Equipment Manuals
  4. Snow Blower
  5. 100536
  6. Operator's manual

Champion Power Equipment 100536 Operator's Manual

30 in. 2-stage snowblower
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OPERATOR'S MANUAL
MODEL #100536
30 iN. 2-STAgE SNOwbLOwER
REGISTER YOUR PRODUCT ONLINE
at championpowerequipment.com
or visit championpowerequipment.com
READ AND SAVE THiS MANUAL. This manual contains important safety precautions which should be read and understood before operating the product. Failure to
do so could result in serious injury. This manual should remain with the product.
Specifications, descriptions and illustrations in this manual are as accurate as known at the time of publication, but are subject to change without notice.
REV 20200821
Champion Power Equipment, Inc., Santa Fe Springs, CA USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 100536 and is the answer not in the manual?

Questions and answers

Related Manuals for Champion Power Equipment 100536

Summary of Contents for Champion Power Equipment 100536

  • Page 1 This manual should remain with the product. Specifications, descriptions and illustrations in this manual are as accurate as known at the time of publication, but are subject to change without notice. REV 20200821 Champion Power Equipment, Inc., Santa Fe Springs, CA USA...

  • Page 2: Table Of Contents

    TAbLE Of CONTENTS 100536 - 30 iN. 2-STAgE SNOwbLOwER TAbLE Of CONTENTS After Use ............Maintenance ..........introduction ........... Engine Maintenance ..........

  • Page 3: Introduction

    100536 - 30 iN. 2-STAgE SNOwbLOwER iNTRODUCTiON SAfETY DEfiNiTiONS Congratulations on your purchase of a Champion Power Equipment The purpose of safety symbols is to attract your attention to (CPE) product. CPE designs, builds, and supports all of our possible dangers. The safety symbols, and their explanations, products to strict specifications and guidelines.

  • Page 4: Important Safety Instructions

    SAfETY iNSTRUCTiONS 100536 - 30 iN. 2-STAgE SNOwbLOwER iMPORTANT SAfETY iNSTRUCTiONS wARNiNg  Sparks can result in fire or electrical shock. wARNiNg  When servicing the engine: Cancer and Reproductive Harm – www.P65Warnings.ca.gov Disconnect the spark plug wire and place it where it cannot contact the plug.

  • Page 5: Training

    SAfETY iNSTRUCTiONS 100536 - 30 iN. 2-STAgE SNOwbLOwER Training – Only fill or drain gasoline outdoors in a well-ventilated area. – DO NOT pump gasoline directly into the snowblower at the gas 1. Read the Operator’s Manual completely before attempting to station.

  • Page 6: Operation

    SAfETY iNSTRUCTiONS 100536 - 30 iN. 2-STAgE SNOwbLOwER Operation 18. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition prior to operation. 1. Do not put hands or feet near or under rotating parts. Keep 19.

  • Page 7: Safety Labels

    - changed to “87” octane. process magenta This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for outside parties without the explicit consent of Champion Power Equipment.

  • Page 8: Safety Symbols

    SAfETY iNSTRUCTiONS 100536 - 30 iN. 2-STAgE SNOwbLOwER Safety Symbols Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to more safely operate the product.
  • Page 9 SAfETY iNSTRUCTiONS 100536 - 30 iN. 2-STAgE SNOwbLOwER SYmBOL mEaNING hot Surface. To reduce the risk of injury or damage, avoid contact with any hot surface. Open Flame alert. Fuel and its vapors are extremely flammable and explosive. Keep fuel away from smoking, open flames, sparks, pilot lights, heat, and other ignition sources.

  • Page 10: Operation Symbols

    SAfETY iNSTRUCTiONS 100536 - 30 iN. 2-STAgE SNOwbLOwER Operation Symbols Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to more safely operate the product.

  • Page 11: Quickstart Label Symbols

    5. Priming the Engine This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for 5a. To start the COLD engine: Prime 3-5 times.

  • Page 12: Controls And Features

    CONTROLS AND fEATURES 100536 - 30 iN. 2-STAgE SNOwbLOwER CONTROLS AND fEATURES Read this operator’s manual before operating your snowblower. Familiarize yourself with the location and function of the controls and features. Save this manual for future reference. Snowblower 10. Clean Out Tool 1.

  • Page 13: Parts Included

    CONTROLS AND fEATURES 100536 - 30 iN. 2-STAgE SNOwbLOwER Parts included accessories 6 ft. (1.8 m) Electric Start Power Cord ......

  • Page 14: Assembly

    ASSEMbLY 100536 - 30 iN. 2-STAgE SNOwbLOwER ASSEMbLY 2. Connect the upper and lower handle with bolts (2-1), washers (2-2) and locking knobs (2-3) (Fig. 2). The top handle can Your snowblower requires some assembly. This unit ships from adjust to 4 positions. You can come back later and adjust to a our factory with oil.

  • Page 15: Add Engine Oil

    ASSEMbLY 100536 - 30 iN. 2-STAgE SNOwbLOwER 4. Put the snow discharge chute cable wire form on the snow NOTiCE  discharge support using the washer (4-1) and nut (4-2). Securely tighten the assembly (Fig. 4) using included tool or The recommended oil type for typical use is 0W-30 your own 16mm wrench.

  • Page 16: Add Fuel

    ASSEMbLY 100536 - 30 iN. 2-STAgE SNOwbLOwER 4. If the oil level is near or below the lower limit mark on 2. Add fuel to the bottom of the fuel level limit in the neck of the the dipstick, remove the oil cap/dipstick, and fill with the fuel tank.

  • Page 17: Operation

    OPERATiON 100536 - 30 iN. 2-STAgE SNOwbLOwER NOTiCE wARNiNg   The snowblower engine works well with 10% or less ethanol Always check the engine oil level before operation. Using the blend gasoline. When using ethanol-gasoline blends there are snowblower without oil can seriously damage the engine and some issues worth noting: void your warranty.

  • Page 18: Stopping The Engine

    OPERATiON 100536 - 30 iN. 2-STAgE SNOwbLOwER 3. To start a cold engine: (Fig. 10). 6. To start a cold engine: When the engine starts, move the choke to RUN position. 3a. Move the fuel valve lever to the ON position.

  • Page 19: Control Levers

    OPERATiON 100536 - 30 iN. 2-STAgE SNOwbLOwER Control Levers Auger control handle. Located on the right side handle. Self-drive control handle. Located on the left side handle (figure 13). Pushing this lever towards the handle causes the auger and impeller to When the snowblower has been put activate.

  • Page 20: Adjusting The Snow Discharge Direction And Height

    OPERATiON 100536 - 30 iN. 2-STAgE SNOwbLOwER Adjusting the Snow Discharge Direction and Adjusting the Snow Shoes Height Set the height of the auger housing above the ground using the shoes. Change discharge direction: Adjust the shoes to suit the ground conditions: Discharge chute rotation lever controls the chute either left or right (Fig.

  • Page 21: After Use

    MAiNTENANCE 100536 - 30 iN. 2-STAgE SNOwbLOwER 1. While both the drive and auger control levers are fully – Burns from hot parts — let the engine cool for 30 minutes depressed, release the auger control lever while keeping before touching hot parts.

  • Page 22: Lubrication

    LONg-TERM STORAgE 100536 - 30 iN. 2-STAgE SNOwbLOwER Lubrication No parts inside the gearbox are to be lubricated. All bearings and bushings are permanently lubricated and require no maintenance. Lubricating these parts will only result in the grease getting on to the friction wheel and disc drive plate, which could damage the rubber clad friction wheel.

  • Page 23: Specifications

    SPECifiCATiONS 100536 - 30 iN. 2-STAgE SNOwbLOwER SPECifiCATiONS Oil Specifications DO NOT OVERFILL. Snowblower Specifications Type ............0W-30 Model ............

  • Page 24: Troubleshooting

    TROUbLESHOOTiNg 100536 - 30 iN. 2-STAgE SNOwbLOwER TROUbLESHOOTiNg Problem Cause Solution Repeat start attempts with throttle choke Engine flooded. OFF. Engine fails to start. Water in fuel. Drain tank and refill with fresh fuel. Check carefully the start procedure Other.
  • Page 25 Please register within ten (10) Consequential Damage days from date of purchase. Champion Power Equipment disclaims any obligation to cover any loss of time, use of this product, freight, or any incidental Repair/Replacement Warranty or consequential claim by anyone from using this product.
  • Page 26 THE UNITED STATES ENVIRONMENTAL PROTECTION AGENCY (U.S. EPA) AND THE CALIFORNIA AIR RESOURCES BOARD (CARB) EMISSION CONTROL SYSTEM WARRANTY Your Champion Power Equipment (CPE) engine complies with both the U.S. EPA and state of California Air Resources Board (CARB) emissions regulations.
  • Page 27 EMISSION CONTROL SYSTEM WARRANTY The following are specific provisions relative to your Emission Control System (ECS) Warranty Coverage. 1. APPLICABILITY: This warranty shall apply to 1995 and later model year California small off-road engines (SORE) (for other states, 1997 and later model year engines). The ECS Warranty Period shall begin on the date the new engine or equipment is delivered to its original, end-use purchaser, and shall continue for 24 consecutive months thereafter.
  • Page 28 You must take your CPE engine or the product on which it is installed, along with your warranty registration card or other proof of original purchase date, at your expense, to any Champion Power Equipment dealer who is authorized by Champion Power Equipment, Inc. to sell and service that CPE product during his normal business hours.

Table of Contents