Dell P170ST User Manual

Dell P170ST User Manual

Flat panel monitor

Advertisement

Dell P170S/P190S Flat Panel Monitor User's Guide
Dell™ P170S/P190S Flat Panel Monitor User's Guide
About Your Monitor
Setting Up the Monitor
Operating the Monitor
Solving Problems
Appendix
Notes, Cautions, and Warnings
NOTE:
A NOTE indicates important information that helps you make better use of your computer.
CAUTION:
A CAUTION indicates potential damage to hardware or loss of data if instructions are not
followed.
WARNING:
A Warning indicates a potential for property damage, personal injury or death.
Information in this document is subject to change without notice.
© 2010 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc; Microsoft and Windows are either trademarks or registered
trademarks of Microsoft Corporation in the United States and/or other countries; ENERGY STAR is a registered trademark of the U.S. Environmental
Protection Agency. As an ENERGY STAR partner, Dell Inc. has determined that this product meets the ENERGY STAR guidelines for energy efficiency.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
Model P170Sb/P190Sb/P170St/P190St/P170Sf/P190Sf/P190Sc
January 2010 Rev. A02
file:///S|/SSA_Proposal/P170S_P190S/UG/index.htm[7/8/2011 4:47:10 PM]

Advertisement

Table of Contents
loading

Summary of Contents for Dell P170ST

  • Page 1 Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc; Microsoft and Windows are either trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries;...
  • Page 2: Setting Up Your Monitor

    2. After installing the drivers for your Graphics Adapter, attempt to set the resolution to 1280x1024 again. NOTE: If you are unable to set the resolution to 1280x1024 , please contact Dell™ to inquire about a Graphics Adapter that supports these resolutions.
  • Page 3: If You Have A Non Dell™ Desktop, Portable Computer, Or Graphics Card

    Dell P170S/P190S Flat Panel Monitor Back to Contents Page Setting Up Your Monitor Dell™ P170S/P190S Flat Panel Monitor If you have a non Dell™ desktop, portable computer, or graphics card 1. Right-click on the desktop and click Properties. 2. Select the Settings tab.
  • Page 4: Using The Front Panel Controls

    Using the Front Panel Controls Use the control buttons on the front of the monitor to adjust the characteristics of the image being displayed. As you use these buttons to adjust the controls, an OSD shows the numeric values of the characteristics as they change.
  • Page 5: Using The On-Screen Display (Osd) Menu

    Down (-) and Up (+) Use this button to launch Brightness/Contrast Menu. Brightness/Contrast Use this button to activate automatic setup and adjustment. The following dialog appears on a black screen as the monitor self-adjusts to the current input: Auto Adjust Auto Adjustment button allows the monitor to self-adjust to the incoming video signal.
  • Page 6: Accessing The Menu System

    Accessing the Menu System NOTE:If you change the settings and then either proceed to another menu, or exit the OSD menu, the monitor automatically saves those changes. The changes are also saved if you change the settings and then wait for the OSD menu to disappear.
  • Page 7 Operating the Monitor:Dell P170S/P190S Flat Panel Monitor User's Guide NOTE: Auto Adjust, Positioning and Image Settings are only available when you are using the analog (VGA) connector. Push the - and + buttons to move between the setting options. As you move from one icon to another, the option name is highlighted. See the table below for a complete list of all the options available for the monitor.
  • Page 8 NOTE:In most cases, Auto Adjust produces the best image for your configuration. Image settings: The Phase and Pixel Clock adjustments allow you to more closely adjust your monitor to your preference. These settings are accessed through the main OSD menu, by selecting Image Settings.
  • Page 9 Operating the Monitor:Dell P170S/P190S Flat Panel Monitor User's Guide NOTE:When using DVI source, the Image Settings option is not available. Color Settings Color Settings adjusts the color temperature, color hue, and saturation. The color hue is most noticeable in areas of white.
  • Page 10 Operating the Monitor:Dell P170S/P190S Flat Panel Monitor User's Guide OSD Hold Time OSD Hold Time: The OSD stays active for as long as it is in use. Adjusting the hold time, sets the length of time the OSD remains active after the last time you pressed a button.
  • Page 11 Yes — enables audio No — disables audio (default) Factory Reset: Reset the OSD menu options to the factory preset values. file:///S|/SSA_Proposal/P170S_P190S/UG/operate.htm[7/8/2011 4:48:31 PM] NOTE: When the Dell Soundbar is not properly connected to the monitor, the audio menu is not available.
  • Page 12 IR — This feature will help reduce minor cases of image retention. Enable LCD Conditioning: If an image appears to be stuck on the monitor, select LCD Conditioning to help eliminate any image retention. Using the LCD Conditioning feature may take several hours. Severe cases of image retention are known as burn-in, the LCD Conditioning feature does not remove burn-in.
  • Page 13: Osd Warning Messages

    This means that the monitor cannot synchronize with the signal that it is receiving from the computer. See addressable by this monitor. Recommended mode is 1280 X 1024. NOTE: The floating Dell Self-test Feature Check dialog appears on-screen if the monitor cannot sense a video signal. file:///S|/SSA_Proposal/P170S_P190S/UG/operate.htm[7/8/2011 4:48:31 PM] Monitor Specifications...
  • Page 14: Setting The Maximum Resolution

    Using the Dell Soundbar (Optional) The Dell Soundbar is a stereo two channel system adaptable to mount on Dell flat panel displays. The Soundbar has a rotary volume and on/off control to adjust the overall system level, a blue LED for power indication, and two audio headset jacks.
  • Page 15: Using The Tilt, Swivel, And Vertical Extension

    Using the Tilt, Swivel, and Vertical Extension NOTE: This is applicable for a monitor with a stand. When the OptiPlex™ USFF 780/OptiPlex™ SFF 980 AIO Stand is bought, please refer to the respective AIO stand setup guide for set up instructions.
  • Page 16: Vertical Extension

    Operating the Monitor:Dell P170S/P190S Flat Panel Monitor User's Guide NOTE:Stand is detached and extended when the monitor is shipped from the factory. Vertical Extension Stand extends vertically up to 130mm. Changing the Rotation of Your Monitor Before you rotate the monitor, your monitor should either be vertically extended file:///S|/SSA_Proposal/P170S_P190S/UG/operate.htm[7/8/2011 4:48:31 PM]...
  • Page 17 Operating the Monitor:Dell P170S/P190S Flat Panel Monitor User's Guide Back to Contents Page file:///S|/SSA_Proposal/P170S_P190S/UG/operate.htm[7/8/2011 4:48:31 PM]...
  • Page 18 1: If you have a Dell™ desktop or a Dell™ portable computer with internet access. 2: If you have a non Dell™ desktop, portable computer, or graphics card.
  • Page 19: Setting Up The Monitor

    NOTE: Stand is detached when the monitor is shipped from the factory. NOTE: This is applicable for a monitor with a stand. When the OptiPlex™ USFF 780/OptiPlex™ SFF 980 AIO Stand is bought, please refer to the respective AIO stand setup guide for set up instructions.
  • Page 20: Connecting The Blue Vga Cable

    Connecting the White DVI Cable NOTE: The Graphics are used for the purpose of illustration only. Appearance of the the computer may vary. After you have completed connecting the VGA/DVI cable, follow the procedure below to complete your monitor setup: file:///S|/SSA_Proposal/P170S_P190S/UG/setup.htm[7/8/2011 4:49:17 PM]...
  • Page 21: Organizing Your Cables

    1. Plug the power cables for your computer and monitor into a nearby outlet. 2. Turn on the monitor and the computer. If your monitor displays an image, installation is complete. If it does not display an image, see Organizing Your Cables...
  • Page 22: Removing The Stand

    Dell P170S/P190S Flat Panel Monitor User's Guide 1. Working from the rear of the monitor, attach the Soundbar by aligning the two slots with the two tabs along the bottom rear of the monitor. 2. Slide the Soundbar to the left until it snaps into place.
  • Page 23 NOTE: To prevent scratches on the LCD screen while removing the stand, ensure that the monitor is placed on a clean surface. NOTE: This is applicable for a monitor with a stand. When the OptiPlex™ USFF 780/Optiplex™ SFF 980 AIO Stand is bought, please refer to the respective AIO stand setup guide for set up instructions.
  • Page 24: Solving Problems

    3. Turn on the monitor. The floating 'Dell™ - Self Test Feature Check' dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly. While in self-test mode, the power LED remains green. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll through the screen.
  • Page 25: Common Problems

    The test is complete when the white screen appears. To exit, press the + (button 4) again. If you do not detect any screen abnormalities upon using the built-in diagnostic tool, the monitor is functioning properly. Check the video card and computer.
  • Page 26: Product-Specific Problems

    Check for bent or broken pins in the video cable connector. Change the color to "User Preset" Adjust R/G/B value of "User Preset" Use the Power Management feature to turn off the monitor at all times when not in use (for more information, see Power Management Alternatively, use a dynamically changing screensaver.
  • Page 27 Dell P170S/P190S Flat Panel Monitor User's Guide Distorted Sound Computer's sound card is used as the audio source. Distorted Sound Other audio source is used. Unbalanced Sound Output Sound from only one side of Soundbar Low Volume Volume is too low Back to Contents Page file:///S|/SSA_Proposal/P170S_P190S/UG/solve.htm[7/8/2011 4:49:32 PM]...
  • Page 28: About Your Monitor

    Your monitor ships with the components shown below. Ensure that you have received all the components and NOTE: Some items may be optional and may not ship with your Monitor. Some features or media may not be available in certain countries. NOTE: Stand and cables are not included, when purchased with OptiPlex™...
  • Page 29: Product Features

    Product Features The P170S/P190S flat panel display has an active matrix, thin-film transistor (TFT), and liquid crystal display (LCD). The monitor features include: ■ P170S: 17-inch (432 mm) viewable area display (measured diagonally). 1280 x 1024 resolution, plus full-screen support for lower resolutions.
  • Page 30: Back View

    Front panel controls Description/Use Use to mount the monitor. Refer to this label if you need to contact Dell for technical support. Use a security lock with the slot to help secure your monitor. Attach the optional Dell Soundbar. Lists the regulatory approvals.
  • Page 31: Bottom View

    Dell P170S/P190S Flat Panel Monitor User's Guide Right side Left side Bottom View Bottom view Label Description 1 Power connector Insert the power cable. 2 Dell Soundbar power connector Connect the power cord for the Soundbar (optional). 3 DVI connector Connect your computer DVI cable.
  • Page 32: Monitor Specifications

    Power Management Modes If you have VESA's DPMS™ compliance display card or software installed in your computer, the monitor can autom referred to as Power Save Mode. If input from a keyboard, mouse or other input devices is detected by the comput...
  • Page 33: Dvi Connector

    Dell P170S/P190S Flat Panel Monitor User's Guide Computer 5V/3.3V GND-sync DDC data H-sync V-sync DDC clock DVI Connector 24-pin Side of the Connected Signal Number Cable TMDS RX2- TMDS RX2+ TMDS Ground Floating Floating DDC Clock DDC Data Floating TMDS RX1-...
  • Page 34: Flat Panel Specifications

    NOTE: USB 2.0 capability requires 2.0-capable computer. NOTE: The USB interface of the monitor works ONLY when monitor is powered ON (or in Power Save Mode). Switching your monitor OFF and then ON would re-enumerate its USB interface; attached peripherals may take a few seconds to resume normal functionality.
  • Page 35: Physical Characteristics

    Dell P170S/P190S Flat Panel Monitor User's Guide Video input signals Synchronization input signals AC input voltage/frequency/current Inrush iso surge current Physical Characteristics Model Connector type Signal cable type Dimensions (with stand) Height (Compressed) Height (Extended) Width Depth Dimensions (without stand)
  • Page 36: Plug And Play Capability

    LCD Monitor Quality & Pixel Policy During the LCD Monitor manufacturing process, it is not uncommon for one or more pixels to become fixed in an unchanging state which are hard to see and do not affect the display quality or usability. For more information, see Dell Support site at: support.dell.com.
  • Page 37: Contacting Dell

    Dell product catalog. Dell provides several online and telephone-based support and service options. Availability varies by country and product, and some services may not be available in your area. To contact Dell for sales, technical support, or customer service issues: 1.

Table of Contents