Subnet Mask Address; Gateway Address - Leightronix UltraNEXUS-HD X2 Product Quick Manual

2
Network Configuration
Entering the Front Panel Password
From the front panel of your UltraNEXUS-HD X2 server, press right [
entry screen. Press right [
NOTE: To replace the unit's password, refer to the Changing Front Panel Password section in the full manual.
Editing TCP/IP Network Addresses
Obtain network addresses from your technical support personnel or network administrator.
IP Address
1.
From the CONFIG MENU screen, press up/down
[ ] and navigate to Set IP Address.
2.
Press right [
3.
Press right/left [
editable fields and press up/down [
values. Press right [
fields to enter the next screen.
4.
Either press right [
left [ ] to abort them.

Subnet Mask Address

1.
From the CONFIG MENU screen, press up/down
[ ] to navigate to Set Subnet Mask.
2.
Press right [
3.
Press right/left [
editable fields and press up/down [
values. Press right [
fields to enter the next screen.
How to Properly Shutdown Your UltraNEXUS-HD X2
Press and hold the red X [
EXECUTING SYSTEM SHUTDOWN. After approximately three (3) seconds, SYSTEM HALTING REMOVE POWER will appear
on the front panel display. At this point, all services will be stopped and the operating system will shut down. Power off the
system by pressing 0 on the power switch.
] five (5) times to enter the default front panel password and access configuration menus.
] to select Set IP Address.
] to position the cursor under
] to edit
] at the end of all editable
] again to save changes or
] to select Set Subnet Mask.
] to position the cursor under
] to edit
] at the end of all editable
] on the front panel for approximately seven (7) seconds until the front panel display shows
] from any status screen to display the password
4.
Either press right [
left [ ] to abort them.

Gateway Address

5.
From the CONFIG MENU screen, press up/
down [ ] and navigate to Set Gateway 1.
6.
Press right [ ] to select Set Gateway 1.
7.
Press right/left [
under editable fields and press up/down [
to edit values. Press right [
editable fields to enter the next screen.
8.
Either press right [
left [ ] to abort them.
NOTE: The UltraNEXUS-HD X2 must be rebooted by
holding down the center check mark [
seconds to apply any network address changes.
] again to save changes or
] to position the cursor
]
] at the end of all
] again to save changes or
] for seven (7)