Dell Inspiron 7000 Reference And Troubleshooting Manual page 61

12. Reinstall the options-bay device or PC Cards that you removed in step 3.
13. Replace any batteries that you removed in step 2.
14. Reconnect the computer and peripherals to AC power and turn them on.
15. Does the computer work properly?
Yes. The problem is resolved.
No. If the computer is able to boot, run the Dell Diagnostics to identify computer
damage. If the computer is unable to boot, see "Troubleshooting a Power Fail-
ure" found later in this section. If you cannot identify the damaged component(s),
call Dell for technical assistance. (See Chapter 5, "Getting Help," for
instructions.)
If the computer is dropped or damaged, use the following procedure:
1. Save all your work, exit any open application programs, and remove any installed
batteries.
2. Turn off the computer and disconnect it from the AC adapter. Then disconnect
the AC adapter from AC power. Turn off any attached peripherals and disconnect
them from their power sources and then from the computer.
3. Ground yourself by touching one of the metal connectors on the back of the
computer.
4. Turn the computer over and remove the two screws at the front of the hard-disk
drive carrier. A spring will cause the front edge of the cover to pop up.
5. Pull the hard-disk drive forward until it stops, and then pull it up. When the hard-
disk drive is not in the computer, protect the drive from exposure to static
electricity.
6. Turn the computer over, and remove the memory module cover as shown in
Figure 3-6.
Slide the memory module cover as far as it will go in the direction of the arrow
and then lift it away from the computer.
Troubleshooting Your Computer 3-15