Download Print this page

Epson WorkForce Pro WF-7820 Start Here page 2

Advertisement

2
Gently shake th
e ink cartridges, and remove them from the
packaging.
3
Remove only the yellow tape from each ink cartridge.
Caution:
Do not remove any seals, or ink will leak. Do not touch
the areas shown above. Doing so may prevent normal operation
and printing.
4
Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
5
Close the ink cartridge cover, then lower the scanner unit.
6
The product starts charging the ink. Ink charging takes
approximately 5 minutes. When you see a completion
message on the product's LCD screen, charging is
complete.
Caution:
Don't turn off the printer or raise the scanner unit while
the printer is charging or you'll waste ink.
Note:
As part of setup, your product's serial number will be sent
to a secure Epson server so that you can be eligible to participate
in programs we may offer from time to time, including the Epson
ink replenishment program. You will have a separate opportunity
to consent to participating in such programs.
4
Load paper
See the online User's Guide for information about loading
capacity, available paper types and sizes, loading envelopes,
and using the rear paper feed slot or ADF.
1
Make sure the product is done charging the ink, then pull
out the paper cassette.
2
Slide the side edge guides all the way out and set the
front edge guide to the paper size you are using.
3
Insert paper with the glossy or printable side down.
Note:
Make sure the paper is under the arrow mark for your
paper type and loaded against the front edge of the cassette.
4
Slide the edge guides against the paper, but not too
tightly.
5
Keep the cassette flat as you insert it all the way.
6
Select the paper settings on the product's control panel.

Advertisement

loading

This manual is also suitable for:

Workforce pro wf-7840