Table of Contents
Advertisement
Advanced Features
Use Modulation to Control Playback
Bitbox allows you to modify the values of cell parameters over time by use of internal or external signals. For example, you can
use MIDI Velocity to control the Level of a cell, or EXT1 to vary the panning. You can use a Trigger or CV input to control
which slice of a Slicer cell will be played on the next note event. The parameter tables in this document indicate which
parameters can be used as Modulation Targets. On the parameter screens you can easily identify the Modulation Targets by
the three black boxes that appear below them. You can use up to three different signal sources to modulate each parameter.
The same signal can be used to modulate multiple parameters.
To configure modulation for a parameter:
1.
From the Main screen, touch the cell you want to modulate.
2.
Press INFO until you see the parameter you want to modulate.
3.
Touch one of the three black boxes below the parameter to display the
Modulation Parameters screen.
4.
Use the Control Knobs to select a value for the Source parameter. This
parameter specifies which signal will be used to control this parameter. Available
values are:
None – no modulation source will be used.
•
TRIG – any input that is used to trigger a cell, such as CV input,
•
touch, or MIDI Note.
VEL – MIDI Velocity
•
EXT1 through EXT8 – External CV input as shown in Figure 31: EXT
•
Ports
5.
Use the Control Knobs to select the Amount of modulation that will be applied.
This is used to increase or decrease the amount of impact the modulation will have on this parameter. This parameter
does not apply to Slice Seq modulation.
6.
If you are modulating Pitch or Slice Sel, you can optionally turn on the 1V/Octave setting. When this is set to
OFF, the Amount parameter controls how the voltage maps to pitch or slice selection. When this is ON, 1V
difference in CV maps to one octave difference in pitch playback. In this case, 1/12
Each semitone of voltage level changes the pitch or slice selection by 1.
NOTE
EXT1 through EXT8 can be used as modulation sources when these cells are triggered via CV. Modulation will not be
•
applied for these modulation sources when MIDI is used to trigger them.
1/30/19 2:45 PM
Page 30 of 39
Digital Heart – Analog Soul
Bitbox 2.2 User's Manual
Figure 3 0: Mo dulation
P arameters Sc reen
Figure 3 1: EXT Po rts
th
of a volt maps to one semitone.
Copyright 1010music LLC 2019
Advertisement
Table of Contents
