Diagnostic Lights - Dell Dimension 2350 Owner's Manual

Diagnostic Lights

To help you troubleshoot a problem, your computer is equipped with four lights on the back
panel labeled "A," "B," "C," and "D" (see page 70). These lights can be yellow or green.
When the computer starts normally, the lights flash. After the computer starts, the lights
remain green. If the computer malfunctions, the color and sequence of the lights identify
the problem.
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 12.
Light Pattern
Y Y
A B
G Y
A B
54
Advanced Troubleshooting
Problem
Description
G G Memory modules are
detected, but a
memory failure has
occurred.
C D
G Y Memory modules are
detected, but a
memory
configuration or
C D
compatibility error
exists.
Suggested Resolution
• If you have one memory module installed,
reinstall it (see page 83) and restart the
computer.
• If you have two or more memory modules
installed, remove the modules, reinstall one
module (see page 83), and then restart the
computer. If the computer starts normally,
reinstall an additional module. Continue
until you have identified a faulty connector
or reinstalled all modules without error.
• If available, install properly working memory
of the same type into your computer (see
page 83).
• If the problem persists, contact Dell (see
page 100).
• Ensure that there are no special memory
module/memory connector placement
requirements (see page 83).
• Verify that the memory modules that you are
installing are compatible with your computer
(see page 93).
• If the problem persists, contact Dell (see
page 100).