Table of Contents
Advertisement
Specifications:
Model
Sound conversion principle
Capsule
Directional characteristics
Frequency range
Sensitivity
Equivalent noise level
Max. SPL
Signal-to-noise ratio
Sampling rate
Required connector
Troubleshooting:
The following overview serves as an aid for quick troubleshooting. If you are unsure, contact the
manufacturer, the dealer or the corresponding specialist personnel.
Symptom
No tone
Delayed tone
If the specified corrections have not led to success, please contact our service staff. The contact
details can be found at www.musicstore.de
Studio CU1 USB condenser microphone
USB condenser microphone
22 mm Electret Diaphragm Capsule
Cardioid
30 Hz – 18 kHz
-32 dB (OdB = 1V/PA @ 1 kHz)
< 22 dB, A-weighted
140 dB (@ 1kHz≤1% T.H.D.)
68 dB
16 Bit, 48 kHz
USB (included)
Troubleshooting
Check the USB cable for damage (cuts, extreme
kinks, etc.).
Check the wiring. Connectors must be fully
inserted and snap into place!
Arm the microphone in the DAW or activate direct
monitoring.
Check the sound settings of your operating
system. If necessary, select the microphone as the
input device.
The microphone may need to be levelled. Refer to
the software manual of the DAW (Digital Audio
Workstation) in question.
Change the buffer size in the DAW settings. The
lower the number, the lower the latency. (Note:
with a low buffer size, the machine requires higher
performance. Depending on the computer, this
can lead to higher performance losses).
ENGLISH
Advertisement
Table of Contents
