Husqvarna LT 5005 Operator's Manual page 13

6. Fill with new oil through the hole for the sight glass.
Technical data on page 17 for the correct
Refer to
type of oil.
7. Install the sight glass and tighten it fully.
8. Do a check of the oil level.
To do a check of the oil level in the
rammer leg
1. Put the product in upright position.
2. Look at the sight glass (A). The oil level is correct
when it is at the middle of the sight glass.
A
To tighten the bolts on the rammer
shoe
• Tighten the 13 bolts on the rammer shoe with a
wrench.
To clean or replace the air filter
WARNING: Use approved respiratory
protection when you clean or replace the air
filter. Discard used air filters correctly. The
dust in the air filter is dangerous to your
health.
WARNING: Do not clean the air filter with
compressed air. This causes damage to the
air filter and the risk increases that you
breathe the dangerous dust.
957 - 002 - 14.10.2019
13x
1. Examine the air filter indicator. If the air filter
indicator is on red, it is necessary to replace the air
filter.
2. Turn the locking knob counterclockwise and fold the
cover forward.
3. Remove the air filter from the air filter housing.
4. Clean the air filter housing with a brush.
5. Tap the air filter against a hard surface or use a
vacuum cleaner to remove the particles.
13