Husqvarna LT 5005 Operator's Manual page 12

3. Clean the oil from the dipstick.
4. Put the dipstick back fully into the oil tank.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 17 for the correct type of oil.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Engine oil is very hot directly
after the engine stops. Let the engine
become cool before you drain the engine oil.
If you spill engine oil on your skin, clean with
soap and water.
1. Put a container below the drain plug for the engine
oil.
2. Remove the oil drain plug.
12
3. Tilt the product and let the oil run out into the
Technical data
4. Install the oil drain plug and tighten it.
5. Fill with new engine oil. Refer to
6. Do a check of the engine oil level.
To replace the oil in the rammer leg
1. Put a container below the oil drain plug.
2. Remove the oil drain plug.
3. Let the oil run out into the container.
4. Install the oil drain plug and tighten it. Make sure that
5. Remove the sight glass.
container.
page 17 for the correct type of oil.
the sealing washer is not damaged.
Technical data on
957 - 002 - 14.10.2019