Husqvarna LT 5005 Operator's Manual page 11

General product maintenance
Replace the oil in the rammer leg.
Tighten the bolts on the rammer shoe.
Examine the vibration damping units for damage.
Examine the cover knob for damage.
Engine maintenance
Do a check of the fuel level and the engine oil level.
Do a check of the air filter indicator. Clean or replace the
air filter.
Clean the cooling fins of the engine.
Replace the engine oil.
Replace the air filter.
Do a check of the engine speed.
Examine and clean the spark plug. Replace the spark
plug if it is necessary.
Clean the spark arrester screen on the muffler.
Adjust the valve head clearance for the air intake and the
exhaust valves.
Drain the fuel and clean the fuel tank and the fuel filter.
Drain water from the fuel system.
Replace the fuel filter.
To clean the product
CAUTION: Before you clean the product,
attach a plastic bag tightly around the fuel
tank cap. This is to make sure that water
does not go into the venthole in the fuel tank
cap.
• Use running water from a hose or a high-pressure
washer to clean the product.
CAUTION: Do not point the water
directly at the fuel tank cap, electrical
components or the engine.
• Use solvent to clean mechanical parts.
• Remove grease and oil from the handle.
957 - 002 - 14.10.2019
Before use, After the
each 10 h first 20 h
X
X
Before use, After the
each 10 h first 20 h
X
X
O
X
X
O
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To do a check of the engine oil level
1. Put the product in an upright position.
2. Remove the oil tank cap and dipstick.
Weekly, Yearly, each
each 100 h 500 h
X
X X
X
Weekly, Yearly, each
each 100 h 300 h
X
X X
X X
O O
O O
O O
O
O
O
O
11