Step 2 Choosing The Installation Location - Samsung AJ RBLDEG Series Installation Manual

Installation Procedure
Step 2 Choosing the installation
location
WARNING
• Because your air conditioner contains R-32
refrigerant, make sure that it is installed, operated,
and stored it in a room whose floor area is larger
than the minimum required floor area specified in the
following table:
Ceiling-mounted type
m (kg)
≤ 1.842
1.843
1.9
2.0
2.2
2.4
2.6
2.8
3.0
3.2
3.4
3.6
3.8
4.0
4.2
4.4
4.6
4.8
5.0
- m : Total refrigerant charge in the system
- A : Minimum required floor area
• IMPORTANT: it's mandatory to consider either the
table above or taking into consideration the local law
regarding the minimum living space of the premises.
• Minimum installation height of indoor unit is 0.6 m
for floor mounted, 1.8 m for wall, 2.2 m for ceiling.
General requirements for installation location
Do not install the air conditioner in a location where it
will come into contact with the following elements:
• Combustible gases
6
English
• Saline air
• Machine oil
• Sulphide gas
• Special environmental conditions
Avoid installing the air conditioner in a location with the
following conditions:
• In areas where it is exposed to direct sunlight. Close
• In damp areas or locations where it could come into
A (m²)
• In areas where curtains and furniture could affect the
No requirement
3.64
• Without leaving the required minimum space around
3.75
3.95
• In scarcely ventilated areas.
4.34
• On surfaces that are unable to support the weight
4.74
5.13
5.53
• In a position that does not enable the condensate
5.92
6.48
7.32
• The place where animals may urinate on the product.
8.20
9.14
• The place where is close to heat sources.
10.1
• Do not use the indoor unit for preservation of food
11.2
12.3
13.4
• Do not install the indoor unit if it has any drainage
14.6
15.8
Space requirements for installation
Construction Standard for Inspection Hole
1 In case, the ceiling is tex tile, Inspection hole dose not
2 In case, the ceiling is plaster board, Inspection hole
to heat sources.
contact with water. (for example rooms used for
laundry)
supply and discharge of air.
the unit. (as shown in the drawing)
of the unit without deforming, breaking or causing
vibrations during the use of the air conditioner.
drainage pipe to be correctly installed. (at the end
of the installation. It is always essential to check the
efficiency of the drainage system)
Ammonia may be generated.
items, plants, equipment, and art works. This may
cause deterioration of their quality.
problem.
need.
depends on Inside height of the ceiing.
a Height is more than 0.5m : Only "B" [Inspection
for PBA] is applied.
b Height is less than 0.5m : Both "A"&"B" are
applied.
c "A"&"B" are inspection holes .