Advertisement
Electronic Control Operation
On-the-Fly Cooking
On-the-Fly Cooking allows the user to start another cook cycle while the oven is
operating or paused.
Note: User Option OP:51 must be enabled for use of On-the-Fly cooking.
1.
While the oven is cooking or while in Pause Mode, press a Number Key to
automatically start the Preset Program associated with that key.
2.
Oven begins cooking and the LED displays cooking time.
At the end of the cooking cycle, the oven beeps and LED displays "End".
3.
User Option Mode
This allows the user to customize various oven settings.
Open oven door and press Number Key "2" for 5 seconds. Oven beeps and LED
1.
displays "OP: - -".
2.
Press any Number Key to enter related options as noted in chart below.
3.
To change, repeat pressing the Number Key until desired setting is reached.
4.
Press START key
indicate selection was saved and another option change can be made.
5.
To exit User Option Mode, press STOP/RESET key
Note: If START key
is not pressed as the last step, the selected option will not
be saved.
NUMBER KEY
DISPLAY
1
OP:10
End of Cycle Beep
OP:11
OP:12
2
OP:20
Key Beep Volume
OP:21
OP:22
OP:23
3
OP:30
Key Beep
OP:31
4
OP:40
Active Display
OP:41
OP:42
OP:43
5
OP:50
On-the-Fly Cooking
OP:51
6
OP:60
Reset Door Open
OP:61
7
OP:70
OP:71
Maximum Heating
Time
8
OP:80
Manual Operation
OP:81
9
OP:90
Double Digit
OP:91
Operation
*Note: Factory setting may vary by model
to save the selected setting. LED displays "OP: - -" to
OPTIONS ( FACTORY SETTINGS IN BOLD )
3 second beep
Continuous beep until door is opened
5 beep bursts until door is opened
Eliminates beep
Sets volume to low
Sets volume to medium
Sets volume to high
Prevents beep when pad is pressed
Allows beep when pad is pressed
15 seconds after oven door is opened, keyboard disabled
30 seconds after oven door is opened, keyboard disabled
1 minute after oven door is opened, keyboard disabled
2 minutes after oven door is opened, keyboard disabled
Prevents different pre-programmed pads to be activated during cooking
Allows different pre-programmed pads to be activated during cooking
Allows oven to resume heating time countdown after door is opened during cycle
Cancels heating time count down after door is opened during cycle.
Allows 30 minutes of heating time
Allows 10 minutes of heating time
Allows use of preprogrammed pads only
Allows use of manual time entry and preprogrammed pads
Allows 10 (0-9) preprogrammed pads
Allows 20 (00-99) preprogrammed pads
and close door.
CHANGING USER OPTION
EXAMPLE:
To set the key beep volume to high.
1.
Open oven door and press Number
Key "2" for 5 seconds.
LED
displays "OP: - -".
Press Number Key "2". "OP:22"
2.
displays.
To change, repeat pressing "2".
3.
LED displays "OP:20", "OP:21",
"OP:22", "OP:23" etc. Stop
pressing once "OP:23" displays.
4.
Press START key
to save the
selected setting. LED displays "OP:
- -" to indicate selection was saved
and another option change can be
made.
Advertisement
