Use Of The Manual; General Safety Rules; Safety Instructions - Stanley SW22 Manual

ENGLISH
(Original instructions)
DO NOT RETURN THIS PRODUCT TO THE STORE, first
contact your local STANLEY office or nearest authorized
service center.

USE OF THE MANUAL

The manual forms an integral part of the appliance and should
be kept for future reference. Please read it carefully before
installing/ using the unit. If the appliance is sold, the seller
must pass on this manual to the new owner along with the
appliance.
SAVE THESE INSTRUCTIONS
The appliance you have purchased is a technologically
advanced product designed by one of the leading
manufacturers of high pressure pumps. To obtain the best
performance from your unit, read this booklet carefully and
follow the instructions each time you use it. We congratulate
you on your choice and wish you successful operation.

GENERAL SAFETY RULES

SAFETY INSTRUCTIONS

General power tool safety warnings.
Warning! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions listed below may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future reference. The
term in all of the warnings listed below refers to your mains
operated (corded) power tool or battery operated (cordless)
power tool.
1. Safety "Must Nots"
a. Explosion or poisoning hazard. Do not use the
appliance with inammable or toxic liquids, or any products
which are not compatible with the correct operation of the
appliance.
b. Injury hazard. Do not direct the water jet towards people
or animals.
c. Electric shock hazard. Do not direct the water jet
towards the unit itself, electrical parts or towards other
electrical equipment
d. Short circuit hazard. Do not use the appliance outdoors
in case of rain.
e. Injury hazard. Do not allow children or incompetent
persons to use the appliance.
f. Electric shock hazard. Do not touch the plug and/or
socket with wet hands.
g. Electric shock and short circuit hazard. Do not use the
appliance if the electrical cable is damaged.
h. Explosion hazard. Do not use the appliance if the high
pressure hose is damaged.
i. Accident hazard. Do not jam the trigger in the operating
position.
6
j. Accident hazard. Check that the data plates are axed to
the appliance, if not, inform your dealer. Units without
plates must not be used as they are unidentiable and
potentially dangerous.
k. Explosion hazard. Do not tamper with or alter the
calibration of the safety valve.
l. Hazardous alteration of operating performance. Do not
alter the original diameter of the spray head nozzle.
m. Accident hazard. Do not leave the appliance unattended.
n. Short circuit hazard. Do not move the appliance by
pulling on the electrical cable.
o. Make sure that cars do not drive over the high pressure
hose.
2. Safety "Musts"
a. Short circuit hazard. All electrical conductors must be
protected against the water jet.
b. Electric shock hazard. The appliance must only be
connected to an adequate power supply in compliance
with all applicable regulations.
• Use of a safety residual current circuit-breaker
(R.C.C.B.) will provide additional protection for the
operator (30mA).
c. Injury hazard. The high pressure may cause materials to
bounce o surfaces at speed; therefore protective clothing
and safety goggles must be worn.
d. Accidental start-up hazard. Before doing work on the
appliance, remove the plug.
e. Injury hazard. Before pressing the trigger, grip the gun
rmly to counteract the recoil.
f. Contamination hazard. Comply with the requirements of
the local water supply company. According to DIN 1988,
the appliance may only be connected to the mains
drinking water supply if a backow preventer valve with
drain facility is installed in the supply hose. Water that has
flowed through backflow preventers is considered to be
non-potable.
g. Accident hazard. Maintenance and/or repair of electrical
components must be carried out by qualied and
Authorized STANLEY staff for the warranty to take effect. If
the supply cord is damaged, it must be replaced by the
manufacturer, an Authorized STANLEY service centre or
an equally qualied person in order to avoid a hazard. If the
supply cord is replaced by an equally qualied person, but
not Authorized by STANLEY, the warranty will lose effect.
h. Injury hazard. Discharge residual pressure before
disconnecting the unit hose.
i. Accident hazard. Before using the appliance, check
every time that the screws are fully tightened and that
there are no broken or worn parts.
j. Explosion and electric shock hazard. Only use
detergents which will not corrode the coating materials of
the high pressure hose/electrical cable.
k. Injury hazard. Ensure that all people or animals keep a
minimum distance of 16yd. (15m) away.