Page 2
ENGLISH FIG. A f For house hold use only Note: The diagrams are for reference, the product may change in appearance or specifications without notice.
Page 3
ENGLISH FIG. B Ø13 S/N. Fabricado na China...
Page 5
ENGLISH FIG. E FIG. F 1 ÷ 25 m 25 ÷ 50 m Volt 220-240 V~ 50 Hz 3 x 1,5 mm 3 x 2,5 mm Note: The diagrams are for reference, the product may change in appearance or specifications without notice.
USING THE MACHINE head nozzle. DO NOT RETURN THIS PRODUCT TO THE STORE, m. Accident hazard. Do not leave the appliance first contact your local STANLEY office or nearest authorized unattended. service center. n. Short circuit hazard. Do not move the appliance by pulling on the electrical cable.
Page 7
STANLEY, the warranty will not be valid.. Warning! Water that has flowed through backflow preven- ters is considered to be nonpotable.
ENGLISH LABELS ON TOOL Starter device (12) The following symbols are shown on the tool along with the The starter device prevents accidental use of the appliance. date code: Caution! Safety devices: Do not tamper with or adjust the safety valve setting. f Safety valve and/or pressure limiting valve.
Page 9
ENGLISH b. When the gun trigger is depressed, the automatic Connection points: drop in pressure starts the motor and the pressure is restored after a very slight delay; Water outlet (OUTLET) c. If the TSS is to function correctly all gun trigger Water inlet with filter (INLET) releasing and depressing operations, must be Connection to the mains water supply...
SERVICE INFORMATION Warning! Always disconnect the plug from the power STANLEY offers a full network of company-owned and authorized socket before carrying out any work on the appliance. service locations. All STANLEY Service Centers are staffed with...
ENGLISH TROUBLE SHOOTING PROBLEM POSSIBLE CAUSES SOLUTION Nozzle worn Replace nozzle Water lter fouled Clean filter (6) (Fig. E) Insufficient water supply Turn on water supply tap fully Air being sucked into system Check tightness of hose fittings Switch off the appliance and keep depressing Pump does not reach working pressure and releasing the gun trigger until the water Air in pump...
Page 12
ENGLISH TSS versions only: No water delivery when gun trigger is depressed Nozzle clogged Clean nozzle (Fig. E) (With supply hose connected) Adjustable nozzle on high pressure setting (Fig.C) “ ” set nozzle setting Detergent too dense Dilute with water No detergent sucked in High pressure hose extension being used Fit original hose...