Mounting The Fuel Tank; Installing The Muffler - Toro 30140 Operator's Manual

1
4
4
3
Figure 11
1. Shift lever, 2nd gear
2. Shift lever plate

Mounting the Fuel Tank

1. Align fuel tank with the top of the rear frame (Fig. 12).
2. Secure the right side of the fuel tank to the rear frame
with 2 bolts (5/16 x 7/8 inch), lock washers (5/16 inch)
and washers (5/16 inch) (Fig. 12).
3. Secure the left side of the fuel tank to the rear frame
with 2 studs, washers (5/16 inch), springs and locknuts
(5/16 inch) (Fig. 12).
Note: Tighten left side of the fuel tank until it is completely
tight and then unscrew locknut one full turn. This will
allow the spring to work.
3
2
1
Figure 12
1. Bolt, 5/16 x 7/8 inch
2. Lock washer, 5/16 inch
3. Washer, 5/16 inch
4. Slide the hose clamp onto the fuel line (Fig. 13).
2
Rear View
2
m–7454
3. Shift lever, neutral
4. Equal distance
m–3771
4
3
5
6
4. Stud
5. Spring
6. Locknut
17
5. Push the fuel line onto the fuel tank connection and
secure it with a hose clamp (Fig. 13).
3
Figure 13
1. Fuel line
2. Hose clamp

Installing the Muffler

1. Loosen the clamp (Fig. 14).
1
Figure 14
1. Muffler
2. Clamp
2. Rotate the muffler forward into the position shown in
Figure 14.
3. Secure the muffler bracket (Fig. 14) to the engine
bracket with the hardware provided.
4. Tighten the clamp.
2
1
m–6442
3. Fuel fitting
3
2
m–5941
3. Muffler bracket