Toro 30140 Operator's Manual page 23

1
2
Figure 24
1. Axle pivot bolt
Adjusting the Caster Position
1. Using the height-of-cut chart, adjust the caster spacers
to match with the axle hole selected (Fig. 25).
2. Remove clevis pin, slide caster from support and
change spacers (Fig. 25).
3. Install caster in support and insert clevis pin (Fig. 25).
2
Figure 25
1. Clevis pin
2. Spacer, 3/16 inch (5 mm)
A
B
C
D
E
m–3789
2. Axle adjustment bolt
1
3
m–3791
3. Spacer, 1/2 inch (13 mm)
23