Table of Contents
Advertisement
Water intake fault
Problem
The in-operation indica-
tor light is flashing
quickly.
The alarm tone is
sounding.
One of the following
messages appears in
the display:
Open the water supply
Insufficient water. Open
the water supply all the way.
Refer to Operating Instruc-
tions if necessary
Fault F 18: A technical
fault has occcurred. Turn off
the appliance, close the wa-
ter supply and contact Miele
Service.
The following fault mes-
sage appears during the
program:
EnergySaver
Intake temperature too low
Frequently Asked Questions
Possible cause and solution
The water supply is turned off.
Open the water supply all the way.
Before remedying the fault:
Turn off the dishwasher.
There is a problem with the water intake.
Turn on the water supply fully and start the pro-
gram again.
Clean the filter in the water intake (see "Cleaning
the filter in the water intake" under "Cleaning and
care").
The water-connection pressure is lower than
7.25 psi (50 kPa).
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see "Water drainage" under "Installa-
tion").
A technical fault has occurred.
Turn off the dishwasher.
Turn off the water supply.
Contact Miele Customer Service.
The intake water has not reached the required tem-
perature of 115 °F (45 °C) (see "Water intake" under
"Installation").
Start the program again.
If the fault message appears again, select a differ-
ent program.
83
Advertisement
Table of Contents
