Table of Contents
Advertisement
Display of program duration
The estimated duration of the selected
program appears on the display before
the program begins. If the door is
opened during the program, the time
left until the end of the program is dis-
played.
The displayed duration may vary for the
same program. It is influenced by, for
example, the temperature of the incom-
ing water, the reactivation cycle of the
water softener, the detergent type, the
amount of dishware, and how soiled it
is.
When a program is selected for the first
time, the display will show the average
program duration for a cold water con-
nection.
The program durations shown under
"Program overview" refer to standard
test loads and temperatures.
Each time a program is run, the control
module calculates the program duration
required depending on the temperature
of the water taken into the dishwasher
and the amount of dishes.
Starting a program
Start the program by closing the door
within 4 seconds of the last press of a
button.
If necessary, confirm the previously
displayed message with OK.
The in-operation indicator light comes
on to show that a program has been
started.
If you do not close the door within
4 seconds, the message
to continue
will appear in the display.
The program cannot be started until
you confirm the message by press-
ing the OK button and close the door
within 4 seconds.
If you open the door, the message
ware can be added
As long as this message is showing,
dishware can be added without com-
promising wash results.
Risk of scalding due to hot wa-
ter.
During operation, water in the dish-
washer may be very hot.
During operation, only open the door
with extreme caution.
Operation
Press "OK"
may be displayed.
Dish-
55
Advertisement
Table of Contents
