Related Manuals for Quantum QN-H-220
Summary of Contents for Quantum QN-H-220
- Page 1 Quick Setup Guide Model: QN-H-220 High Performance 802.11ac (2x2) Wave 2 Indoor (Room) Access Point www.qntmnet.com...
-
Page 2: Table Of Contents
Contents Before You Begin ..........................3 Package Contents ..........................3 Prerequisites ............................3 Connect Access Point .......................... 3 Step 1- Access Point Initial Configuration ..................4 Step 2- Setting Up Device IP Address ....................4 Step 3- Access Point Quick Setup in Standalone Mode ..............5 Step 4- Access Point Quick Setup in Cloud Controlled Mode ............ -
Page 3: Before You Begin
Access Point (AP) on site and provide wireless network access to users. Before You Begin Your Quantum Networks’ Access Point can work in “Standalone Mode” or can be managed by “Cloud Controller”. To manage Access Point by “Cloud Controller”, please follow step 5 first and then step 1. For “Standalone Mode”, continue with step 1. -
Page 4: Step 1- Access Point Initial Configuration
Step 1- Access Point Initial Configuration Connect WAN port of the Access Point to network with internet access. You should see a new wireless network with SSID QN_XX:XX (where XX:XX are last four digits of Access Point MAC Address). ... -
Page 5: Step 3- Access Point Quick Setup In Standalone Mode
Management Mode Quantum Networks’ Access Point can be configured in two modes: Standalone Independent management of each Access Point Cloud Controlled Centralized management of Access Points using QN-RUDDER Step 3- Access Point Quick Setup in Standalone Mode Select “Management Mode” as “Standalone”, if each Access Point is to be configured and managed individually. -
Page 6: Step 4- Access Point Quick Setup In Cloud Controlled Mode
Step 4- Access Point Quick Setup in Cloud Controlled Mode Select “Management Mode” as “Cloud Controlled”, enter cloud login credentials and click “NEXT”. (If you do not have an account on QN-RUDDER, please refer Step 5) Select Cloud Controller site, where Access Point needs to be added and click “Next”. ... -
Page 7: Reset Access Point To Factory Defaults
Follow the steps as guided on screen for Registration. Verify QN-RUDDER account from registered email id. Your Account on QN-RUDDER (Quantum Networks’ Cloud Controller) is now ready to use. Reset Access Point to Factory Defaults o Power on the Access Point o Push the reset button on back panel and hold it for 10 seconds. -
Page 8: Fcc Statement
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.