Bestway 58497 Manual page 7

Assembly (You will need a screwdriver.)
1. Carefully remove all components from
the package and check to ensure
nothing is damaged. If equipment is
damaged,immediately notify the
retailer from where the equipment
was purchased.
2. The sand filter should be placed on
solid, level ground, preferably a
concrete slab. Position the sand filter so the Ports and
Control Valve are accessible for operation, servicing and
winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to
be vertically fixed on ground or a certain pedestal made of
wood or concrete before use to prevent the sand filter from
accidentally falling. Fully assembled sand filter will exceed
18 kg. The mounting holes should be 8 mm in diameter
and spaced 86 mm apart. Use two bolts and nuts with a
maximum of 8 mm in diameter to fasten the sand filter to
the pedestal.
Load pool-grade filter sand/Flowclear™ Polysphere.
NOTE: Use only special pool-grade filter sand, free of all
limestone or clay: #20 Silica sand 0.45-0.85 mm, approximately
one 9 kg bag should suffice. If you do not use the
recommended size filter sand, filtering performance will be
reduced and the sand filter may damaged, thereby voiding
warranty.
NOTE: To avoid damaging the Skimmer when adding sand,
pour some water into the Bottom Tank to submerse the
Skimmer on the Collector Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace
1 kg (2.20 lbs) sand.
303021216268_58497_14x21cm_1500gal 欧规砂滤器说明书-英
Ф8 mm
7
86 mm