Filter In The Water Supply Is Blocked; Faults And What To Do About Them; Emergency Release - Siemens WN54A2A0HK Instruction Manual And Installation Instructions

Faults and what to do about them

en
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
Turn off the water tap.
1.
Select the Cottons v (activate (
2.
varioSpeed setting) programme.
If your appliance with
Note:
intelligent dosing system
need to deactivate the intelligent
dosing system.
Select the I Start/Reload button.
3.
Allow the programme to run for
approx. 40 seconds.
Turn the programme selector to Û
4.
(Off).
Pull out the mains plug.
5.
Clean the filters:
Disconnect the hose from the rear of
1.
the appliance.
Use pliers to remove the filter.
2.
* Depending on the module
46
3.
* , you also
4.
3
E mergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m
E.g. power outage or in the event of a
loss of power
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the appliance door can be
opened as follows:
:
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
Clean the filter with a small brush.
Connect the hose and check for
leaks.
Faults and what to do
about them
Warning