Installation; Cleaning The Terminal Block - National Instruments SCXI-1325 Installation Manual

4
1 Serial Number
2 Wire Entry Side

Installation

Cleaning the Terminal Block

© National Instruments Corporation
Figure 2 shows the SCXI-1325 signal connections.
3
Figure 2. SCXI-1325 Signal Connections
To connect the terminal block to the SCXI module front connector, perform
the following steps:
1. Connect the module front connector to its mating connector on the
terminal block.
2. Tighten the top and bottom thumbscrews on the back of the terminal
block to hold it securely in place.
Clean the terminal block by brushing off light dust with a soft, nonmetallic
brush. Remove other contaminants with deionized water and a stiff
nonmetallic brush. The unit must be completely dry and free from
contaminants before returning to service.
3 Assembly Number
4 Product Name
5
1
2
SCXI-1325 Installation Guide