Table of Contents
Advertisement
Display
E:35
alternating with
-10 and End
when programme is
finished (Suitable for
special models)
Other displays
Faults and what to do about them
Faults
Water is leaking from the
appliance.
The door cannot be
opened.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
The programme will not
start.
The programme has
started and the drum is
rotating, but the drum is
not filling with water.
Start/Pause A button
cannot be operated.
Cause/Remedy
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
Turn the programme selector to Off, wait for five seconds and then switch it on
again. If the display appears again, call customer services.
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
■
The temperature in drum is too high to open the door.
■
The safety function is activated. Stop the programme?
■
The water level in drum is too high.
■
Can the door only be opened by the emergency release?
■
~ "Emergency release" on page 45
Programme does not start?
■
Is the tap turned on?
■
Could the filter in the water supply be blocked?
■
~ "Filter in the water supply is blocked" on page 44
Note:
If an additional water filter has been installed (depending on the
model), check for contaminants and clean if required ~ separate installa-
tion and cleaning instruction for water filter.
Is the supply hose kinked or trapped?
■
Have you touched the Start/Pause A button or selected ñ Ready In?
■
Is the door closed?
■
Childproof lock activated? Deactivate childproof lock.
■
Shop mode activated? If the display shows à•‹ for 5 s after you have
■
switched on the appliance, the appliance is in shop mode. Wait for the dis-
play message à•‹ to disappear. Touch and hold Start/Pause A for at
least 5 s. ‹"" will appear in the display panel. Turn the programme selec-
tor to Off. Now you already turned off the shop mode. You can use the
appliance now as usual.
Not a fault – Some programme specifically detect and weigh the load after the
programme has started in order to calculate the optimum amount of water for
washing. The drum will then start filling with water.
ù is continuously lit. The detergent drawer has not been pushed in fully. Push
the detergent drawer in fully.
Faults and what to do about them
en
47
Advertisement
Table of Contents
