Table of Contents
Advertisement
Altering or deactivating the charcoal
filter operating hours counter
The charcoal filter is needed for
recirculation mode.
You can set the operating hours counter
to suit the type of cooking you do.
It has to be deactivated for extraction
mode.
It is set at the factory for 180 hours of
use before the filters need replacing.
Switch off the fan and the lighting.
Touch the run-on control and the
charcoal filter control at the same
time.
The charcoal filter symbol and one of
the fan power levels will flash.
The fan power level indicators 1 to B
show the time set:
1............................................. 120 hours
2............................................. 180 hours
3............................................. 240 hours
B ......................................... deactivated
Touch the relevant control to select
the duration required.
Confirm your choice by touching the
charcoal filter touch control .
All the indicator lights will go out.
If you do not confirm your selection
within 4 minutes, the rangehood will
automatically revert to the previous
setting.
Operation (automatic and manual modes)
Reading the filter operating hours
counter
You can check the percentage of time
set already used before the filters need
replacing.
Switch the fan on with the On/Off
touch control .
Press and hold the grease filter
control or the charcoal filter
control .
One or more of the power level
indicators will flash.
The number of flashing indicators
shows the percentage of the operating
time which has already been used up.
1 ................................................... 25 %
1 and 2 ........................................ 50 %
1 to 3 ........................................... 75 %
1 to B ......................................... 100 %
The number of operating hours used
remains in the memory even when the
appliance is switched off or there is a
power cut.
31
- Quick Links:
- Installation
Hide quick links:
Advertisement
Table of Contents
