Advertisement
Quick Links
Deploy the ExtraHop Discover 1200
Appliance
Published: 2020-06-08
This guide explains how to install the EDA 1200 ExtraHop Discover appliance.
System requirements
Your environment must meet the following requirements to deploy the EDA 1200:
• Power supply: 100-240v power source
• Network access: Two 10/100/1000 BASE-T network ports. One configured as the management port and
the other configured as the monitoring port.
Front panel
•
Power button
•
Two USB 3.0 ports
Rear panel ports
•
Four USB 3.0 ports to connect a keyboard.
•
Two DisplayPorts to connect an external display.
•
Two 10/100/1000 BASE-T network ports. Port 1 is the primary management port and port 2 is the
primary monitor port.
•
One audio input and output port. The audio ports are disabled.
•
One power port to connect the EDA 1200 to an AC power source.
©
2020 ExtraHop Networks, Inc. All rights reserved.
Advertisement
Related Manuals for ExtraHop EDA 1200
Summary of Contents for ExtraHop EDA 1200
- Page 1 Two 10/100/1000 BASE-T network ports. Port 1 is the primary management port and port 2 is the primary monitor port. • One audio input and output port. The audio ports are disabled. • One power port to connect the EDA 1200 to an AC power source. © 2020 ExtraHop Networks, Inc. All rights reserved.
- Page 2 Connect an Ethernet cable from network port 2 on the back of the appliance to the mirror port on your switch. Connect the power cord to the power port on the back of the EDA 1200, and then plug the cord into a power outlet. The appliance powers on automatically.
- Page 3 After you configure an IP address for the Discover appliance, open a web browser and navigate to the ExtraHop Web UI through the configured IP address. Accept the license agreement and then log in with the setup user account. The password is the serial number that appears on the label on the bottom of the appliance.