ExtraHop Discover 8200 Manual

Deploy the ExtraHop Discover 8200
Appliance
Published: 2020-01-18
This guide explains how to install the rack-mounted EDA 8200 ExtraHop Discover appliance.
Installation prerequisites
To install the Discover appliance, your environment must meet the following requirements:
Appliance
1U of rack space and electrical connections for 2 x 750 W power supplies.
Management
One 10/100/1000 BASE-T network port for appliance management.
Monitoring (capture)
High performance interfaces: One to two network ports for connection to 25 GbE or 10 GbE sources
of packet data.
Management + monitoring interfaces: One to three network ports for connection to 1 GbE sources of
packet data.
Network Access
The TCP 443 port must be open between the Discover appliance and any system that connects to the
appliance for administration through the ExtraHop Admin UI.
For more information about the interfaces on the Extrahop appliance, see the
Rear panel ports
EDA 8200
• One iDRAC interface port
• One RS-232 serial port to connect a console device
• One VGA port to connect an external display
• Two USB 3.0 ports to connect input devices such as a keyboard and mouse
• Two power ports to connect the appliance to an AC power source
• Four 10/100/1000 BASE-T network ports. Port 1 is the primary management port. Ports 2 - 4 are the
management + monitor ports.
• Two 25 GbE-capable ports on two network adapters. Ports 5 and 6 are the high performance monitoring
(capture) interfaces.
Appliance Hardware FAQ
©
2020 ExtraHop Networks, Inc. All rights reserved.
.