Makita DUN501W Instruction Manual page 11

The angle of the head can be adjusted in 6 steps. To
change the angle of the head, follow the steps below.
1.
Hold the head and the slide sleeve as shown in
the figure.
1
► 1 . Head 2. Slide sleeve
2. Move the head while holding down the slide
sleeve, and then release the slide sleeve.
3. Move the head slightly until it is locked with a click.
NOTE: Make sure that the head is securely locked
before operating the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the blades.
Installing or removing the shear
blades
CAUTION:
Attach the blade cover before
removing or installing the shear blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
NOTICE:
Do not install 600 mm shear blades to
your tool. If 600 mm shear blades are installed to the
tool, you cannot fold the head of the tool.
NOTE: Before installing or removing the shear
blades, unfold the head of the tool so that the head is
straight to the tool body.
1. Place the tool upside down, and then remove 6
bolts.
2
► 1 . Bolt
2.
Remove the cover, gasket, plate A, and plate B.
► 1 . Cover 2. Gasket 3. Plate A 4. Plate B
NOTE: The gasket or plates may remain on the cover.
3. Remove the rod and the bearing.
► 1 . Rod 2. Bearing
NOTE: The rod or bearing may remain on the cover.
11 ENGLISH
1
2
1
1
2
3
4