Advertisement
- Spin each wheel make sure the wheel rotates smoothly indicating that the bearings are
undamaged.
Assembly Instructions:
Use
- Hold both handgrips firmly. Put one foot towards the front of the deck, push off the
ground to propel the scooter forward with other foot. Both feet can fit on the deck when
desired speed has been reached.
- Practice foot positioning at slower speed until you build skill and experience. Shifting
your foot position, or lifting or placing your feet while travelling affects the stability of the
scooter. You have to learn to maintain control while you move your feet on and off the
deck of the scooter.
- Braking: Brake is located at the rear, when necessary, press down on it to slow down.
Press down gradually in order to prevent skidding or loss of stability. The brake may heat
up after multiple uses. Avoid touching it during and after use.
- Shoes are mandatory and we strongly advise you to wear long pants and long sleeve
shirts to avoid injury if you fall.
1. Loosen the clamp on steering tube. Slide
the tube onto the fork until it is touching the
fork headset washers.
2. Tighten the upper bolt one quarter of a turn
and the lower bolt one quarter of a turn using
the hex key provided. Repeat until the clamp
is tight and the handlebars are secure.
3. Make sure the wheel faces forward when
the handlebars are held facing straight.
WARNING! Failure to tighten the clamp
fully will result in the handlebars not being
secure and the scooter will be unsafe to
ride. Over tightening one bolt before the
other will make it impossible to tighten the
clamp fully.
2
Advertisement
