Table of Contents
Advertisement
Huawei FusionServer Pro 5885H V5 Server
Technical White Paper
Port
Serial port
Management
network port
USB port
PSU sockets
Issue 09 (2020-06-05)
Type
RJ45
1000BASE-T
USB 3.0
-
Copyright © Huawei Technologies Co., Ltd.
Quantity
Description
1
Default operating system
serial port used for debugging.
You can also set it as the iBMC
serial port by using the iBMC
command.
NOTE
The port uses 3-wire serial
communication interface, and the
default baud rate is 115,200 bit/s.
1
Used for server management.
NOTE
The management network port is
a GE port that supports 100
Mbit/s and 1000 Mbit/s auto-
negotiation.
2
Used to connect to a USB
device.
NOTICE
Before connecting an external
USB device, check that the USB
device functions properly. The
server may operate abnormally if
an abnormal USB device is
connected.
4
Used to connect to the power
distribution unit (PDU) in the
cabinet. You can select the
number of power supply units
(PSUs) as required.
NOTE
● When determining the
● If only one PSU is used,
5 Hardware Description
quantity of PSUs, ensure that
the rated power of the PSUs
is greater than that of the
server.
Predicted PSU Status cannot
be set to Active/Standby on
the iBMC WebUI.
23
Advertisement
Table of Contents
