Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for BERNHARDT design traction
Summary of Contents for BERNHARDT design traction
- Page 1 2018...
- Page 3 Instructions and Warnings SAVE THESE INSTRUCTIONS WARNING Risk of injury, electrical shock or fire! Rated at 120 Volts, 12 Amps, 1440 Watts, 60 Hz Use only grounded SJT 14 AWG cord. Do not operate this equipment unless properly trained.
- Page 4 Dual Under Mount Power Module The dual under mount power module is offered for the Traction training table. The module is available as (1) receptacle and (1) dual port USB, shown below. This unit is a great option because it leaves the worksurface free of any distraction and allows for the full use of the entire top.
- Page 5 Power Module Control Unit Bernhardt design explores new ways to connect power with Interlink IQ’s Power Infeed. The power infeed allows the user to connect up to (8) under mount power modules or (4) surface mount power modules off a single infeed. The power infeed was also created with smart LED indicators that illuminate green when you’re connected and ready to plug in.
- Page 6 4 tables may be connected to a single power infeed. The dual under mount power configuration uses a (1) receptacle and (1) dual port USB module that comes mounted at the edge of the table. The power assembly and the Traction tables are UL 962 and CSA 22.2, No.
- Page 7 (8) tables may be connected on a single power infeed. The surface mount power configuration uses a (2) receptacle / (1) dual port USB module flush mounted in the center of the table. The power assembly and the Traction tables are UL 962 and CSA 22.2, No.
Need help?
Do you have a question about the traction and is the answer not in the manual?
Questions and answers