Page 3
Instructions and Warnings SAVE THESE INSTRUCTIONS WARNING Risk of injury, electrical shock or fire! Rated at 120 Volts, 12 Amps, 1440 Watts, 60 Hz Use only grounded SJT 14 AWG cord. Do not operate this equipment unless properly trained.
Page 4
Dual Under Mount Power Module The dual under mount power module is offered for the Serif training table. The module is available as (1) receptacle and (1) dual port USB, shown below. This unit is a great option because it leaves the worksurface free of any distraction and allows for the full use of the entire top.
Page 5
No adapter should be used with these power modules. SJT Power Cord Ganging Bracket Ganging brackets are an optional purchase for Serif. This element levels out table tops, lateral or cross linking. Open Position Closed Position Close grey flap handle to pull tops Lift grey handle to release top.
Page 6
(4) tables may be connected from a single power infeed. The dual under mount configuration uses (1) receptacle and (1) dual port USB module mounted at the edge of the table. The Serif tables with power assembly are UL 962 and CSA 22.2, No. 203.2 approved. The illustration below is a Serif starter table which must be specified to begin a run of tables.
Page 7
(2) receptacle/(1) dual port USB module flush mounted in the center of the table. The Serif tables with power assembly are UL 962 and CSA 22.2, No. 203.2 approved. The illustration below is a Serif starter table with must be specified to begin a run of tables.
Need help?
Do you have a question about the Serif and is the answer not in the manual?
Questions and answers