11-5.Setting Of Larger Pipe Connection And No Insulation On Liquid Line - Daikin RXSQ24TAVJUA Installation Manual

11-5 Setting of larger pipe connection and no insulation on liquid line
When using existing piping, make the following settings.
No.
MODE TEST
Setting
H1P H2P
item
Existing k h
4
pipe
connection
In case of "Not insulated" (Setting# 1 or 3), the field settings for indoor units below are also required.
· Selection of thermistor  "Only remote controller thermistor".
If the above setting is not set, thermo-off indoor unit might exert heating capacity.
Caution: Failure to follow the instruction may lead to damage due to sweating and cause compressor damage and void warranty.
English
Setting item display
C/H selection
Low
noise
IND Master Slave
H6P
H3P H4P H5P
h h k h
Setting condition display
Demand
H7P
Standard pipe connection
Gas side: Standard
diameter
Existing pipe connection
· Gas side: Larger pipe
· Liquid side: No inslated
h
Existing pipe connection
· Gas side: Larger pipe
· Liquid side: Inslated
Existing pipe connection
· Gas side: Standard
diameter
Factory setting
k h h h h h h
k h h h h h k
k h h h h k h
k h h h h k k
19