Table of Contents
Advertisement
Inserting the rotary spit
Place the rotary spit holder on the baking tray (Fig.
1.
A).
Place the rotary spit in the holder (Fig. B).
2.
Insert the baking tray at level 1. There is an opening
3.
in the back wall of the oven. The rotary spit hooks
into this (Fig. C).
Remove the handle and close the oven door (Fig.
4.
D).
Setting the rotary spit and grill
To turn on the rotary spit, follow the instructions below.
If you want to grill food using the rotary spit, it must be
fitted before you carry out the instructions below.
Open the top cover. The top cover must remain
1.
open for as long as the cooker is in operation.
Turn on the main gas supply to the appliance. Insert
2.
the plug into the socket.
Insert the protecting plate into the groove below the
3.
control panel.
Insert the protecting plate with the longer edge at the
front and the curvature at the bottom.
Secure the protecting plate in the groove below the
control panel using the retainers.
Ensure that the protecting plate is engaged in the
retainers. If the protecting plate cannot be removed,
it is properly engaged. You can now safely use the
protecting plate. If it can be removed, insert it into
the groove at a slightly higher angle and make sure
that it engages in the retainers.
Close the oven door so that it is as close as possible
4.
to the protecting place.
Push in the function selector and turn it clockwise to
5.
the ignition position
Keep the function selector pressed in and turn it to
6.
the grill setting
(
.
Keep the function selector pushed in for 10 seconds
so that the safety pilot starts up. The gas coming
from the gas grill is ignited.
Check whether the flame is still lit. If the flame goes
7.
out, repeat the process from step 5.
Press the multi-function button. The rotary spit is
8.
switched on. The oven light comes on.
Once the food is cooked, switch off the function
9.
selector. Press the multi-function button. The rotary
spit is switched off. The oven light goes out. Once
the oven has cooled down, remove the protecting
plate.
:
Warning – Caution!
The hotplate control should not be actuated for longer
than 15 seconds. If the burner does not ignite within 15
seconds, wait at least 1 minute before repeating the
procedure.
Rotisserie spit
8
.
en
21
Advertisement
Table of Contents
